|
How to adjust his putting
小智 发表于 2012/5/28 15:19:00 |
Up in the morning before practice the physical, empty play there putter
morning to go swimming. Swim 500 meters, and do strength exercises.
Go
to North Lake in the evening to practice, play mat exercises 400
goals, 300 goals in full-swing practice. 55 goals in real grass
practice addition, the green side of more than 100 practice chipping,
50 bunker shot practice.
And
then spent some time on my putter. Since I use the abdominal putter
grip position alone has changed many times. Hands at the beginning as
close to the head, and later his hands as much as possible close to the
body; the beginning of next right hand, left hand, and later changed
to the right hand, left hand the next.
Want
to shoulder turn on the pole and the next shot at the beginning,
adjusted to promote on the rod with his left arm, right arm to promote
the next shot, and later adjusted to use the shoulder to the upper and
lower pole.
The
abdominal putter advantage is good stability to reduce the hands
involved in making the putter stability increases, reduced interference
putter factors. I repeatedly see the players on the Tour abdominal
putter also seen them putting video, but did not see why.
Abdominal
putter heavy, so as far as possible putter like a pendulum swinging
more reasonable, which is the abdominal putter. It now appears that
this point or not properly implemented.
I
went to night workshop, the workshop wanted the master to help me the
abdominal putter shaft angle adjustment, because I want to head closer
to the body, which is more conducive to the clubhead swing.
However,
because the angle of the shaft and head, if the head closer to the
body, head away from the body part will be the first rub, this will
affect the effect of the head ball, so I hope that the master can the
angle of the shaft and head up.
Workshop
of the master told me, because the shaft is steel, and cast out strong
to pull the shaft may break. Elasticity of steel, even able to flip
that will bounce back.
He
mentioned two ways: First, to move in curved steel body of the tool;
The other is the local strong heating of the shaft is turning to flip.
It
now appears that these two methods are not very properly, because I am
not very clear point of view that I now need to go through several
tests can know.
It now appears that the push rod adjustment is a difficult thing, I do not know how to deal with.
Callaway RAZR X Black Irons
Callaway FT Irons
Callaway RAZR X Forged Irons |
|
|
